Lockout tagout procedures are dictated by OSHA Reg. 29 CFR 1910.147) and in Canada (CSA Z460). These two Workplace Electrical Safety Standards govern the standards by which Lockout Tagout is executed in all businesses in North America. Local electrical occupational health and safety authorities have jurisdiction to administer, regulate, inspect a company's Lockout Tagout Procedures to ensure electrical worker safety.
The following steps are a good example of a lockout tagout procedures plan:
Step 1 - Preparations Before Lockout Tagout
The first step in these lockout tagout procedures is to prepare to shut down the electrical equipment or machinery.
Before shutting down any electrical equipment or machinery, the authorized electrical employee(s) must be sure they know:
Step 2 - Equipment Shutdown
Machinery and electrical equipment must be deenergized or turned off or shut down using the exact lockout tagout procedures your company has established for the machinery or equipment.
A proper and orderly equipment shutdown must be conducted to avoid additional or increased electrical hazards due to this equipment shutdown.
If more than one authorized, electrical employee is involved in the equipment shutdown, an authorized, recognized, team leader should insure all employees have accomplished their various tasks and are completely aware that an equipment shutdown will occur.
Step 3 - Energy Isolation
All energy isolating devices must be located and operated to completely de-energize and isolate the equipment.
Authorized employees will verify operation of each energy isolating device. If more than one authorized employee is involved in this, an authorized and recognized team leader should insure that all employees have accomplished their work.
Step 4 - Lockout or Tagout Application
Step 5 - Controlling Stored Energy
Immediately after applying lockout or tagout devices, the authorized employee must ensure that all potentially dangerous stored or residual electrical energy is:
If there is a possibility of stored electrical energy reaccumulating to a hazardous level...continue to verify isolation until the servicing or maintenance is completed or until the possibility of such accumulation no longer exists.
Before starting work on a machine or piece of equipment that has been locked or tagged out, the authorized employee must that the machine or piece of equipment has been isolated and deenergized.
Step 6 - VERIFY
Prior to commencing work on machinery or piece of electrical equipment that has been locked or tagged out, the authorized employee must make certain that the machine or piece of equipment has been isolated and deenergized.
For more information, see: